Rhin-o-tuff OD4012 Manuel d'utilisateur télécharger pdf (Page 15)

Machine does not cycle

Symptom Possible Cause

Action

Troubleshooting

Die does not go into machine

1) Machine is off

2) Machine is not plugged in

3) Foot-pedal is not plugged into

machine

4) Die lock handle is not locked

5) Reversing tool is in machine

1) Pin retainer interference

2) Punch is stopped in mid cycle

3) Die lock handle is in lock position

1) Check power switch

2) Check both ends of power cord

3) Make sure foot-pedal cable is

attached to machine.

4) Lock the die lock handle

5) Remove reversing tool and

store properly

1) Make sure pin retainer enters slot

in pusher-bar.

2) Restart machine by turning power

off and back on

3) Move handle to unlock position

Only qualified personnel should attempt to

work on this equipment. There are no user

serviceable parts inside of the machine.

Your machine has been designed for years of trouble free operation. The

following is a troubleshooting guide to help you through some of the

problems that may be encountered.

The OD4012 has earned the UL Listing Mark. E179574.

The OD4012 and OD4000 have been tested with a

duty cycle of 25 cycles per minute with a 1 minute

rest period after 2 minutes of run time. Operating outside of these limits

could result in machine damage.

DANGER

Hazardous voltage

inside.

Disconnect power

before servicing.

NOTICE

1 2 ... 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Rhin-o-tuff OD4012 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Rhin-o-tuff OD4012